This lower brace will be used to hold the base and lights of the table up. The lower brace is just slightly off the ground. Then spray paint the inside of the box with metallic spray paint and the lid. One brace is level with the top of all the sides. To make your light table, use a table with a flat surface for the base of the box. They worked perfectly! As you'll notice in the picture below, we did not use a solid piece for the back of the table. We used MDF pieces that were once the sides of the entertainment center. This brace will just add extra support to the acrylic in the event a child climbs on top because you know that's bound to happen! Both of my boys have been found sitting on the light table, so I'm so glad we added this support brace in.ģ. We used a piece of MDF from the entertainment center. Make sure it is level with what would be the top of the frame so that the acrylic will be level when it is set on top. Using another piece of 2x4 or a thin piece of MDF, add a brace in the middle of the frame. So our acrylic was 28" x 30", which means the outside dimensions of the frame were also 28" x 30".Ģ. The outside of the frame should be the exact same width and length as your piece of acrylic. Make a frame for the acrylic to sit on using 2x4s. You are now done! Hahaha.that is really all we did, but here's the more detailed step by step.ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |